The stone engraving machine can carry out calligraphy and painting on natural stone, glass, ceramics, etc. This equipment is fully automatic computer controlled. The use of equipment for engraving saves manpower and greatly improves work efficiency. When using the machine, according to the normal operation method, the machine will not be in trouble. When the machine is used for a period of time, there will be a failure, and a fault will occur. How to analyze the fault and how to solve the fault problem?
If the machine has reached the limit during the running process, an overtravel alarm will occur. If it is checked, it depends on the designed graphic size to see if this is beyond the processing range. Check if the line connecting the axis of the machine and the lead screw is loose. If it is sent, you need to tighten the screws. If the machine and the computer are not properly grounded, an over-range alarm will occur. To view it, you need to check this part. In the range where the coordinate value exceeds the soft limit value, the alarm will also be available.
To cancel the report, all motion axes need to be automatically set to the jog state. Always press and hold the manual direction button. If the machine leaves the limit position, it will resume motion immediately. Removing the soft line alarm can clear the coordinates in the coordinates. Any machine will have a fault. Stone engraving machine manufacturers can solve the problem by analyzing the cause of the fault.
