Woodworking engraving machines are used more and more widely, and maintenance is also important at the same time. After the work of the woodworking engraving machine is completed, the table surface should be cleaned in time. The material scraps next to the guide rails should be cleaned up in time to prevent the phenomenon of the card machine. The screw is very important in the equipment, which determines the accuracy of the machine, so the screw is cleaned regularly. It is also very important to prevent foreign matter from adhering on the lead screw; dust is the biggest influencing factor of the circuit board, and the industrial control box must be cleaned regularly.
Oiling plays an important role in the maintenance of woodworking machines. After cleaning the guide rail and the lead screw, the oil is on the oil; the refueling cycle is usually once every two weeks; after adding the oil, remember to move back and forth slowly to ensure the degree of lubrication; if the woodworking engraving machine is not used for a long time, it should be refueled regularly. go.
We all know that the production line machinery and equipment need regular inspection and maintenance to ensure its excellent performance. During the inspection process, I often ignore the detection of newly replaced parts.
Before replacing the parts, some maintenance personnel do not perform technical inspections on the new parts and directly install them on the construction machinery. This is unscientific. At present, the quality of spare parts sold on the market is uneven, and some counterfeit and shoddy parts are mixed with beads; some accessories have changed performance due to excessive inventory time. If they are not tested, they often cause failure after assembly.
After disassembling the side cover of the new oil cooler, it was found that the oil seal ring at the side cover was not compacted, causing the oil and water to mix, because the quality of the oil cooler was not good. One ZL50 loader, the diesel engine oil pressure is too low, the analysis is that the oil filter is clogged, replaced with a new oil filter, the test machine oil pressure is still low. Therefore, it is necessary to carry out necessary inspection tests before replacing new parts. The inspection includes appearance and performance tests to ensure that the new parts are free from malfunctions and prevent unnecessary troubles caused by them.
Although regular inspection and replacement of damaged parts of woodworking engraving machine can effectively reduce the probability of failure, we must also check the quality and matching degree of the newly replaced parts, so that the wood engraving machine can operate normally.
